404
Gearcase
Shifter, Bearing and Seal Servicing
Install the magnet into the shift lever, aligning the
hole in the magnet with the holes on the shift
lever.
With shifter detent in NEUTRAL, install arms of
shift lever into detent slots. Align the pivot holes
and insert the retaining pin. Push shifter detent
down.
Rest the cradle on the shift shaft.
Place the shift lever arms into the recesses of the
shift cradle. Pull shifter detent back up to NEU-
TRAL position to hold the cradle and shaft in
place.
Coat thrust bearing and thrust washer with Needle
Bearing grease. Place the bearing on the back of
the gear. Set the washer on top of the thrust bear-
ing. Insert the gear, bearing, and washer into the
bearing housing.
If these parts are damaged or removed, a new
service kit should be installed. Refer to parts cata-
log for kit part number.
Coat thrust bearing and thrust washer with Needle
Bearing grease. Place the bearing on the back of
the gear. Set the washer on top of the thrust bear-
1. Magnet
2. Hole on shift lever
009524
1. Shifter detent
2. Shift lever
3. Pin, shift lever
009556
1. Cradle
2. Shift shaft
009525
WARNING
Wear safety glasses to avoid injury.
1. Clutch Shaft Retainer Kit
2. Clutch Shaft
009560
To Next Page
Loading...
