160
IFS 125M User Manual Bruker Optik GmbH
Web Interface 8
Special commands A and B
The Special commands A and B page items contain commands for setting parameters.
Some of them cannot be set using the OPUS software.
Note that these parameter settings are used for all subsequent measurements until
these parameters are reset, or the spectrometer is switched off.
Possibly, the following commands are useful for testing and diagnostics purposes. Some
of them can also be entered as direct commands.
Command Definition
LSR Laser ON/OFF: This command effects a HeNe laser switch-off and a laser
error without opening the optics compartment. The corre
-
sponding error message is displayed in the Message group
field.
Table 8.13: Direct commands
Figure 8.15a: Special commands A Figure 8.15b: Special commands B
To Next Page
Loading...
