Canon LBP6310dn - Configuring the Protocol Settings

07K5-057
This section describes the procedure for specifying the settings using the Remote UI.
In the Remote UI, you can specify the settings by accessing the printer from a Web browser via a network.
Before specifying the settings, see "Attention (Protocol Settings)."
NOTE
When specifying the settings using software other than the Remote UI
You can also specify the settings using the following software.
"FTP Client"
You can specify the settings by accessing the FTP server of the printer using Command Prompt.
"Setting the IP Address Using NetSpot Device Installer"
You can specify the settings using the Canon software, NetSpot Device Installer, in the supplied CD-ROM.
If you want to configure the settings such as the DNS server settings, use the Remote UI or FTP Client.
"Setting the IP Address Using the Printer Status Window"
You can configure the basic protocol settings using the Printer Status Window.
If you want to configure the settings such as the DNS server settings, use the Remote UI or FTP Client.
1
Start the Remote UI, and then log in as Administrator.
"Starting the Remote UI"
2
Select [Network] from the [Device Manager] menu.
3
Click [Change] under [TCP/IP].
Configuring the Protocol Settings
㻞㻡㻤㻌㻛㻌㻠㻡㻞