Comtech EF Data CDM-625A - CONFIG: IP  ANT (Advanced Network Timing); CONFIG: IP  ANT  SNTP (Simple Network Time Protocol)

CDM-625A Advanced Satellite Modem MN-CDM625A
Front Panel Operation Revision 4
6–71
6.2.1.13.4 CONFIG: IP  ANT (Advanced Network Timing)
IP Protocols: SNTP PTP
()
Use the
◄ ►arrow keys to select SNTP or PTP. Press ENTER.
6.2.1.13.4.1 CONFIG: IP  ANT  SNTP (Simple Network Time Protocol)
SNTP: Disabled Time Zone=GMT
Servers: Primary Backup ()
You may use Simple Network Time Protocol (SNTP) to synchronize computer clocks throughout
a computer network when the ultimate performance of the full NTP implementation (as per
RFC-1305 (Requests for Comment No. 1305: Network Time Protocol, Version 3, Specification,
Implementation and Analysis)) is not needed or justified.
Use the
◄ ►arrow keys to navigate between the top line or bottom line operands as needed.
On the top line, use the
◄ ►arrow keys to select SNTP or Time Zone:
For SNTP – Use the
▲▼ arrow keys to select SNTP as Enabled or Disabled.
• When Enabled, SNTP contacts the time server to update the Real-Time Clock (RTC) every
hour.
• When Disabled, no such notifications take place.
For Time Zone – Use the
▲▼ arrow keys to set your desired time zone:
GMT GMT+01:00 GMT+02:00 GMT+03:00 GMT+03:30 GMT+04:00
GMT+04:30
GMT+05:00
GMT+05:30
GMT+05:45
GMT+06:00
GMT+06:30
GMT+07:00 GMT+08:00 GMT+09:00 GMT+09:30 GMT+10:00 GMT+10:30
GMT+11:00
GMT+12:00
GMT+13:00
GMT+14:00
GMT-12:00
GMT-11:00
GMT-10:00
GMT-09:00
GMT-08:00
GMT-07:00
GMT-06:00
GMT-05:00
GMT-04:30 GMT-04:00 GMT-03:30 GMT-03:00 GMT-02:30 GMT-02:00
GMT-01:00
On the bottom line, use the
◄ ►arrow keys to select the Primary or Backup Server submenu.
Press ENTER to continue.
Where “###### Time Server” denotes “Primary Time Server” or “Backup Time Server”:
####### Time Server: 192.168.001.010
Last Update: Never ()