Comtech EF Data CDM-625A - Admin | Firmware; Admin | Firmware

To Next Page

To Previous Page

CDM-625A Advanced Satellite Modem MN-CDM625A

Ethernet-based Remote Product Management Revision 4

7–18

• SNMP Access Level – Use the drop-down list to select Read and Write (default) or Read

Only.

Click [Submit Admin] to save.

7.5.4.2.3 Admin | Firmware Pages

Chapter 4. UPDATING FIRMWARE

Click the Base Modem tab, or, when the optional IP Packet Processor card is installed, the

Packet Processor tab to continue.

7.5.4.2.3.1 Admin | Firmware | Base Modem

Use this page to view the scrollable, read-only status windows that provide information about

the basic unit’s two loaded and operational firmware images.

Figure 7-6. Admin | Firmware | Base Modem page

Boot

This window identifies the firmware number, version, and release date that is loaded upon

power-up/boot up of the unit.

Image 1 / Image 2

These scrollable windows identify the Firmware numbers, versions, and release dates that

comprise the aggregate image load.

Comtech EF Data CDM-625A - Admin | Firmware; Admin | Firmware | Base Modem