EasyManua.ls Logo

Comtech EF Data CDM-625A - Modem Performance Information

Comtech EF Data CDM-625A
756 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CDM-625A Advanced Satellite Modem MN-CDM625A
Serial-based Remote Product Management Revision 4
8–53
8.5.7 Modem Performance Information
Parameter
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to Query
Rx Signal Level
N/A
5 bytes
Query Only.
Returns the value of the Rx signal level in the form xxxxx, where:
xxxxx=Value, in dBm, from -20 thru -90.
NOTE:
If >-20 dBm, returns RSL=GT-20 (GT=‘greater than’)
If <-90 dBm, returns RSL=LT-90 (LT=‘less than’)
If in the range of -20 thru -90dBm, returns RSL=-xx.y (resolution=0.5dB)
EXAMPLE: <0/RSL? >0/RSL=-45.5 (indicates -45.5 dBm)
N/A
RSL?
RSL=xxxxx
(See Description of
Arguments)
Rx Frequency
Offset
N/A
6 bytes
Exception
600L Emulation:
5 bytes
Query only.
Returns the value of the measured frequency offset of the carrier being demodulated, in the form sxxx.x, where:
s=sign (+ or –)
xxx.x=Value, in kHz, from ± 0 thru ± 200.
Resolution=100 Hz
NOTES:
1) Returns 999999 if the demodulator is unlocked.
2) The maximum Rx Frequency Offset corresponds to the Receive Sweep Width (RSW)
EXAMPLE: <0/RFO? >0/RFO=+002.3 (indicates +2.3 kHz)
N/A
RFO?
RFO=sxxx.x
(See Description of
Arguments)
Buffer Fill State
N/A
2 bytes, numeric
Query only.
Returns the value of the buffer fill state in the for xx, where:
xx=Percentage value from 01 to 99
NOTE: Returns 00 if demodulator is unlocked.
EXAMPLE: <0/BFS? >0/BFS=33 (indicates 33%)
N/A
BFS?
BFS=xx
(See Description of
Arguments)
Rx BER
N/A
5 bytes
Query only.
Returns the value of the estimated corrected BER in the form x.xEc, where:
x.x=Value
Ec=Exponent
NOTE: Returns 99999 if the demodulator is unlocked or BER data is unavailable.
EXAMPLE: <0/BER? >0/BER=4.8E3 (indicates BER @ 4.8 x 10
-3
)
N/A
BER?
BER=x.xEc
(See Description of
Arguments)
Rx Eb/No
N/A
4 bytes
Query only.
Returns the value of Eb/No in the form xx.x, where:
xx.x=Value, in dB, from 00 or 16
Resolution=0.1 dB
NOTE: Returns 99.9 if demod is unlocked; returns +016 for values greater than 16.0 dB.
EXAMPLE: <0/EBN? >0/EBN=12.3 (indicates Eb/No @12.3 dB)
N/A
EBN?
EBN=xxxx
(see Description of
Arguments)
Redundancy State
N/A
1 byte, 0 or 1
Query only.
Returns the redundancy state of the unit in the form x, where:
0=Offline
1=Online
EXAMPLE: <0/RED? >0/RED=1 (indicates redundancy state as Online)
N/A
RED?
RED=x
(See Description of
Arguments)
Temperature
N/A
3 bytes
Query only.
Returns the value of the internal temperature sensor (degrees C) in the form sxx, where:
EXAMPLE: <0/TMP? >0/TMP=+26
N/A
TMP?
TMP=sxx
(see Description of
Arguments)

Table of Contents

Related product manuals