CDM-625A Advanced Satellite Modem MN-CDM625A
Front Panel Operation Revision 4
6–102
6.2.8.1.2 FAST: Options Set Register1 or Set Register 2
Chapter 5. FAST ACTIVATION PROCEDURE
FAST: Set register#: ENTER code below
88888888888888888888 then [ENTER] ()
Where ‘#’ is ‘1’ or ‘2’: Use FAST: Options Set Register1 and Set Register 2 to enable new
options in the modem on a per-register basis. It is important to use the appropriate FAST access
code for the appropriate register.
Contact Comtech EF Data Product Support to order the desired options (see Sect. 6.2.8.1.1) – be
prepared to provide the Modem Serial Number. The representative will verify the order and
provide an invoice and instructions, including a register-specific 20-digit FAST Access Code.
ENTER the FAST Access Code that you have obtained from Comtech EF Data carefully using the
front panel keypad or, alternately, the CDM-625A Web Server (HTTP) Interface:
• From the CDM-625A front panel – First, use the
◄ ►arrow keys to select a digit, and then
use the
▲▼ arrow keys to change that digit. Compose the code carefully, and then press
ENTER only when you are ready to execute the upgrade.
The modem responds with “Configured Successfully” upon completion of the
FAST upgrade; the modem then resets to its newly incorporated default configuration.
However, if you ENTER an invalid code, the modem rejects the entry and the unit prompts
you to re-ENTER the code as follows:
Failed to configure. Re-ENTER code.
88888888888888888888 then [ENTER] ()
Repeat the FAST access code entry procedure. Should the code entry error persist, contact
Comtech EF Data Product Support for further assistance.
• From the CDM-625A Web Server Interface – See Sect. 6.5.4.2.5 Admin | FAST.
To Next Page
Loading...
