CDM-625A Advanced Satellite Modem MN-CDM625A
Preface Revision 4
xxx
Recommended Standard Designations
The new designation of the Electronic Industries Association (EIA) supersedes the Recommended
Standard (RS) designations. References to the old designations may be shown when depicting
actual text (e.g., RS-232) displayed on the Front Panel menus, Web Server pages, serial remote
interface, Telnet Command Line Interface (CLI), or unit rear panel. All other references in the
manual refer to EIA designations.
CAUTION – You must carefully review the following information.
Safety and Compliance
Electrical Safety and Compliance
The unit complies with the EN 60950 Safety of Information Technology Equipment (Including
Electrical Business Machines) safety standard.
CAUTION – If the unit is operated in a vehicle or movable installation, make sure the
unit is stable. Otherwise, EN 60950 safety is not guaranteed.
Sect. 3.3 CDM-625A Ground and Power connections
Grounding
CAUTION – PROPER GROUNDING PROTECTION IS REQUIRED: The installation
instructions require that the integrity of the protective earth must be ensured and
that the equipment shall be connected to the protective earth connection at all
times.
The CDM-625A is designed for connection to a power system that has separate
ground, line and neutral conductors. The equipment is
not designed for connection
to a power system that has no direct connection to ground. It is therefore
imperative
during installation, configuration, and operation for you to ensure that
the unit has been properly grounded using the ground stud provided on the rear
panel of the unit.
• In Finland: "Laite on liitettävä suojamaadoituskoskettimilla varustettuun
pistorasiaan."
• In Norway: “Apparatet må tilkoples jordet stikkontakt.”
•
In Sweden: “Apparaten skall anslutas till jordat uttag.”
To Next Page
Loading...
