CDM-625A Advanced Satellite Modem MN-CDM625A
Front Panel Operation Revision 4
6–87
6.2.4 SELECT: Info (Information) Menu Branch
Info: All ID Mode Tx Rx Clocks EDMAC
Drop Insert Remote Alarm-Mask Misc
These read-only screens display the modem’s current configuration information without risking
inadvertent changes. Use the
◄ ►arrow keys to select a parameter. Press ENTER.
After viewing any Info screen except All – Press ENTER or CLEAR to return to the previous
menu.
The display examples that follow are provided for reference only. The information
displayed on these screens will differ depending on your modem’s active
configuration.
6.2.4.1 Info: All
All = Start
(Stop, Start) ()
Use this menu to scroll through and review configuration settings on a sequential basis. The
configuration displays are read-only – no editing is possible.
To view the configurations – Use the
▲▼ arrow keys to select between Stop and Start. Press
ENTER to continue through all the displays.
To discontinue viewing – Press CLEAR, use the
▲▼ arrow keys to select Stop. Press ENTER.
6.2.4.2 Info: ID
Modem Circuit ID:
----A TEST MESSAGE TO SHOW CIRCUIT ID---
This screen displays the 40-character, user-defined unit label, or Circuit ID string, that was
created using the Utility
Circuit-ID menu. The Circuit ID also appears in the title bar of
compatible web browsers for easy unit identification.
6.2.4.3 Info: Mode
Info: Mode: Tx= G.703B:D&I (B8ZS)
Rx= G.703B:IBS (B8ZS)
This screen displays the active operating interface and framing modes that were selected using
the CONFIG: Tx
Mode and CONFIG: Rx Mod menus.
To Next Page
Loading...
