Comtech EF Data CDM-625A - Configuration | ANT | SNTP (Simple Network Timing Protocol)

CDM-625A Advanced Satellite Modem MN-CDM625A
Ethernet-based Remote Product Management Revision 4
7–60
7.5.4.3.11.2 Configuration | ANT | SNTP (Simple Network Timing Protocol)
Sect. K.7.1 Simple Network Timing Protocol (SNTP) (Appendix K. ETHERNET NETWORK
CONFIGURATION)
Simple Network Time Protocol (SNTP) is used to synchronize computer clocks throughout a
computer network when the ultimate performance of the full NTP implementation as per
RFC-1305 (Requests for Comment No. 1305: Network Time Protocol, Version 3, Specification,
Implementation and Analysis) is not needed or justified.
Figure 7-32. Configuration | ANT | SNTP page
SNTP
• Feature – Use the drop-down list to select SNTP operation as Disabled or Enabled.
• Time Zone – Use the drop-down list to select your desired time zone. Available selections
are:
GMT
GMT+01:00
GMT+02:00
GMT+03:00
GMT+03:30
GMT+04:00
GMT+04:30 GMT+05:00 GMT+05:30 GMT+05:45 GMT+06:00 GMT+06:30
GMT+07:00
GMT+08:00
GMT+09:00
GMT+09:30
GMT+10:00
GMT+10:30
GMT+11:00 GMT+12:00 GMT+13:00 GMT+14:00 GMT-12:00 GMT-11:00
GMT-10:00
GMT-09:00
GMT-08:00
GMT-07:00
GMT-06:00
GMT-05:00
GMT-04:30
GMT-04:00
GMT-03:30
GMT-03:00
GMT-02:30
GMT-02:00
GMT-01:00
• Primary / Backup Ethernet Time Server – Enter the desired Time Server’s IP Address in the
form XXX.XXX.XXX.XXX.
• Last Update – This read-only field displays the time and date that the selected server was
last updated. The time in shown military format (HH:MM:SS); the date is shown in DAY-
MONTH-YEAR format in accordance with European convention. This line specifies “Never” if
no update information exists.