Comtech EF Data CDM-625A - Using the Telnet Interface for Telnet Command Line Interface (CLI) Operation

CDM-625A Advanced Satellite Modem MN-CDM625A
Ethernet-based Remote Product Management Revision 4
7–7
7.4.2 Using the Telnet Interface for Telnet Command Line Interface (CLI)
Operation
(LEFT) TeraTerm CLI Example
(RIGHT) PuTTY CLI Example
Figure 7-1. CDM-625A Telnet Command Line Interface (CLI)
1) The CDM-625A Telnet Command Line Interface (CLI) is accessible only when you
install and enable the optional IP Packet Processor.
2) The CDM-625A Telnet CLI uses Telnet TCP Port 107. Be sure to specify this port
when configuring your terminal emulator for CLI operation.
3) The HyperTerminal terminal emulator, while compatible for use with remote
control operations, is not
supported or recommended for CDM-625A Telnet CLI
operation. Instead, for best results Comtech EF Data recommends PuTTY or
Tera Term or as the preferred terminal emulators (
Figure 7-1).