CDM-625A Advanced Satellite Modem MN-CDM625A
Introduction Revision 4
1–7
1.3.7 Fully Accessible System Topology (FAST)
Chapter 5. FAST ACTIVATION PROCEDURE
The CDM-625A Advanced Satellite Modem incorporates a number of optional features. In order
to permit a lower initial cost, you may purchase the unit enabled with only the desired features.
If you wish to upgrade the functionality of a unit at a later date, Comtech EF Data provides Fully
Accessible System Topology (FAST), which permits the purchase and activation of options
through special authorization codes. You may contact Comtech EF Data Product Support to
purchase these unique, register-specific Fast Access Codes, and then load these codes into the
unit using either the front panel keypad or the CDM-625A HTTP (Web Server) Interface.
FAST Accessible Options: Table 1-2 shows the FAST and FAST-accessible hardware options
available for the CDM-625A. The base CDM-625A unit is equipped with Viterbi and Reed-
Solomon codecs. It offers BPSK, QPSK, and OQPSK modulation types, and data rates up to 5.0
Mbps, with all interface types. While it is limited to Closed Network operation, it also includes
EDMAC and AUPC.
Table 1-2. CDM-625A FAST and FAST-accessible Hardware Options
Option Description and Comments
Method
IF band
50-180 MHz BASE UNIT
950-2250 MHz (L-Band) FAST
Forward Error Correction
Viterbi, Sequential and concatenated Reed-Solomon BASE UNIT
LDPC/TPC Codec daughter card HARDWARE
VersaFEC Codec FAST
VersaFEC-2 Codec HARDWARE
Data Rate (base function)
Data rate 18 kbps to 5.0 Mbps FAST
Data rate 18 kbps to 10.0 Mbps FAST
Data rate 18 kbps to 15.0 Mbps
Data rate 18 kbps to 20.0 Mbps FAST
Data rate 18 kbps to 25.0 Mbps FAST
Data Rate (LDPC/TPC function)
Data rate 18 kbps to 5.0 Mbps BASE UNIT
Data rate 18 kbps to 10.0 Mbps FAST
Data rate 18 kbps to 15.0 Mbps FAST
Data rate 18 kbps to 20.0 Mbps FAST
Data rate 18 kbps to 25.0 Mbps FAST
Modulation
BPSK, QPSK, OQPSK BASE UNIT
8PSK, 8-QAM, 8-ARY FAST
32-ARY FAST
All IDR/IBS Open Network features FAST
Drop and Insert