CDM-625A Advanced Satellite Modem MN-CDM625A
Ethernet-based Remote Product Management Revision 4
7–63
Antenna Handover
• Handover Type – Use the drop-down list to select Break Before Make or Make Before
Break.
• Feature – Use the drop-down list to select Antenna Handover operation as Disabled or
Enabled.
• Mode – Use the drop-down list to set the Antenna Handover action as Auto or Manual.
• ACU IP Address – This read-only item displays the IP Address generated by the active
Antenna Controller Unit.
• Communication Port –
• Handover Delay –
• Differential Path Delay –
To Next Page
Loading...
