Control Techniques unidrive sp User Manual

Menus 15 to 17
SM-I/O Plus
Parameter
structure
Keypad and
display
Parameter
x.00
Parameter
description format
Advanced parameter
descriptions
Macros
Serial comms
protocol
Electronic
nameplate
Performance
Feature look-
up table
264 Unidrive SP Advanced User Guide
www.controltechniques.com Issue Number: 7
Figure 5-30 SM I/O Plus Digital Input/Output logic diagram 2
The module has three digital input/outputs (DI/O1 to DI/O3), three digital inputs (DI/O4 to DI/O6) and two relays outputs (DI/07 and DI/O8). The inputs
can operate with positive or negative logic, but the outputs operate with positive logic with high side drivers only. All digital outputs are disabled when
the drive is in the UU condition.
T6 digital input 4
??.??
Any
unprotected
bit
parameter
??.??
X.24
x(-1)
X.14
T6 digital input 4
state indicator
X.04
X.25
??.??
Any
unprotected
bit
parameter
??.??
x(-1)
X.15 X.05
??.??
Any
unprotected
bit
parameter
??.??
X
.26
x(-1)
X.16X.06
The parameters are all shown
at their default setting
0.XX
0.XX
Key
Read-write
(RW)
parameter
Read-only
(RO)
parameter
Input
terminals
Output
terminals
T6 digital
input 4
invert
T6 digital input 4
destination
T7 digital input 5
T7 digital input 5
state
indicator
T7 digital
input 5
invert
T7 digital input 5
destination
T8 digital input 6
T8 digital input 6
state
indicator
T8 digital
input 6
invert
T8 digital input 6
destination
X.29
Positive
logic select
X.29
Positive
logic select
X.29
Positive
logic select
X.17
Relay 1
Relay 2
http://nicontrols.com

Control Techniques unidrive sp Specifications

General

Brand	Control Techniques
Model	unidrive sp
Category	Controller
Language	English