Control Techniques unidrive sp User Manual

Parameter
structure
Keypad and
display
Parameter
x.00
Parameter
description format
Advanced parameter
descriptions
Macros
Serial comms
protocol
Electronic
nameplate
Performance
Feature look-
up table
Menus 15 to 17
SM-SLM
Unidrive SP Advanced User Guide 307
Issue Number: 7 www.controltechniques.com
This parameter specifies the time delay between the drive power-up and the SLM being available in 250ms units.
The sequencer status is used to determine in what state the start-up sequencer is. The states used depend on the option mode operating mode, the
auto-tuning set-up and the load/save requests. The state can be useful in fault finding and for waiting for an operation to complete.
If the sequencer state has not reached RUNNING or TRIP within 60 seconds from the first pass through power-up after the sequencer has been
restarted, then the Solutions Module will trip the drive with Pr x.50 equal to 19.
x.12 SLM power-up delay
Drive modes Open-loop, Closed-loop vector, Servo, Regen
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
31
Operating mode Encoder only
Range Open-loop, Closed-loop, Servo, Regen 0.000 to 9.999
Default Open-loop, Closed-loop, Servo, Regen 0.000
Update rate Backgroud
x.14 Sequencer status
Drive modes Open-loop, Closed-loop vector, Servo, Regen
Coding
Bit SP FI DE Txt VM DP ND RA NC NV PT US RW BU PS
31
Operating mode Host, Encoder only
Range Open-loop, Closed-loop, Servo, Regen 0 to 16
Update rate Backgroud
http://nicontrols.com

Control Techniques unidrive sp Specifications

General

Brand	Control Techniques
Model	unidrive sp
Category	Controller
Language	English