Dell S4048T User Manual

Feature/Capability Support Status for Default VRF Support Status for Non-default
VRF
NOTE: ACLs supported on
all VRF VLAN ports. IPv4
ACLs are supported on non-
default-VRFs also. IPv6 ACLs
are supported on default-
VRF only. PBR supported on
default-VRF only. QoS not
supported on VLANs.
Layer 3 (IPv4/IPv6) ACLs,
TraceLists, PBR, QoS on physical
interfaces and LAGs
Yes No
IPv4 ARP Yes Yes
IPv6 Neighbor Discovery Yes Yes
Layer 2 ACLs on VLANs Yes No
FEED Yes No
Layer 2 QoS Yes Yes
Support for storm-control
(broadcast and unknown-unicast)
Yes No
sFlow Yes No
VRRP on physical and logical
interfaces
Yes Yes
VRRPV3 Yes Yes
Secondary IP Addresses Yes No
Following IPv6 capabilities No
Basic Yes No
OSPFv3 Yes Yes
IS-IS Yes Yes
BGP Yes Yes
ACL Yes No
Multicast Yes No
NDP Yes Yes
RAD Yes Yes
Ingress/Egress Storm-Control
(per-interface/global)
Yes No
Virtual Routing and Forwarding (VRF) 1189

Dell S4048T Specifications

General

Switching Capacity	1.44 Tbps
Rack Units	1U
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Optional
Product Type	Switch
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management Protocol	SNMP, RMON, Telnet, SSH
Features	Quality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)	17.3 in x 16 in x 1.7 in
Operating Temperature	0°C to 40 °C
Operating Humidity	10% to 90% (non-condensing)