EasyManua.ls Logo

Dell S4048T - Page 882

Dell S4048T
1277 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring RIPv2 on Core 2
Core 2 RIP Output
RIP Configuration on Core 3
Core 3 RIP Output
RIP Configuration Summary
Figure 115. RIP Topology Example
RIP Configuration on Core2
The following example shows how to configure RIPv2 on a host named Core2.
Example of Configuring RIPv2 on Core 2
Core2(conf-if-te-2/3)#
Core2(conf-if-te-2/3)#router rip
Core2(conf-router_rip)#ver 2
Core2(conf-router_rip)#network 10.200.10.0
Core2(conf-router_rip)#network 10.300.10.0
Core2(conf-router_rip)#network 10.11.10.0
Core2(conf-router_rip)#network 10.11.20.0
Core2(conf-router_rip)#show config
!
router rip
network 10.0.0.0
version 2
Core2(conf-router_rip)#
Core 2 RIP Output
The examples in the section show the core 2 RIP output.
Examples of the show ip Commands to View Core 2 Information
To display Core 2 RIP database, use the show ip rip database command.
To display Core 2 RIP setup, use the show ip route command.
To display Core 2 RIP activity, use the show ip protocols command.
The following example shows the show ip rip database command to view the learned RIP routes on
Core 2.
Core2(conf-router_rip)#end
00:12:24: %RPM0-P:CP %SYS-5-CONFIG_I: Configured from console by console
Core2#show ip rip database
Total number of routes in RIP database: 7
10.11.30.0/24
Routing Information Protocol (RIP) 882

Table of Contents

Related product manuals