To view the configuration for the enable secret command, use the show running-config command in
EXEC Privilege mode.
In custom-configured privilege levels, the enable command is always available. No matter what privilege
level you entered Dell Networking OS, you can enter the
enable 15 command to access and configure all
CLIs.
Configuring Custom Privilege Levels
In addition to assigning privilege levels to the user, you can configure the privilege levels of commands so
that they are visible in different privilege levels.
Within Dell Networking OS, commands have certain privilege levels. With the privilege command, you can
change the default level or you can reset their privilege level back to the default.
• Assign the launch keyword (for example, configure) for the keyword’s command mode.
• If you assign only the first keyword to the privilege level, all commands beginning with that keyword are
also assigned to the privilege level. If you enter the entire command, the software assigns the privilege
level to that command only.
To assign commands and passwords to a custom privilege level, use the following commands. You must be
in privilege level 15.
1 Assign a user name and password.
CONFIGURATION mode
username name [access-class access-list-name] [privilege level] [nopassword |
password [encryption-type] password Secret]
Configure the optional and required parameters:
• name: Enter a text string up to 63 characters(maximum) long.
• access-class access-list-name: Restrict access by access-class..
• privilege level: The range is from 0 to 15.
• nopassword: No password is required for the user to log in.
• encryption-type: Enter 0 for plain text or 7 for encrypted text.
• password: Enter a string. Specify the password for the user.
• Secret: Specify the secret for the user.
2 Configure a password for privilege level.
CONFIGURATION mode
enable password [level level] [encryption-mode] password
Configure the optional and required parameters:
• level level: specify a level from 0 to 15. Level 15 includes all levels.
• encryption-type: enter 0 for plain text or 7 for encrypted text.
• password: enter a string up to 32 characters long.
To change only the password for the enable command, configure only the password parameter.
3 Configure level and commands for a mode or reset a command’s level.
CONFIGURATION mode
privilege mode {level level command | reset command}
Security 912
To Next Page
Loading...
Need help?
General
