Dell S4048T User Manual

Configure the following required and optional parameters:
• mode: enter a keyword for the modes (exec, configure, interface, line, route-map, or
router)
• level level: the range is from 0 to 15. Levels 0, 1, and 15 are pre-configured. Levels 2 to 14 are
available for custom configuration.
• command: an Dell Networking OS CLI keyword (up to five keywords allowed).
• reset: return the command to its default privilege mode.
Examples of Privilege Level Commands
To view the configuration, use the show running-config command in EXEC Privilege mode.
The following example shows a configuration to allow a user john to view only EXEC mode commands and
all snmp-server commands. Because the snmp-server commands are enable level commands and, by
default, found in CONFIGURATION mode, also assign the launch command for CONFIGURATION mode,
configure, to the same privilege level as the snmp-server commands.
Line 1: The user john is assigned privilege level 8 and assigned a password.
Line 2: All other users are assigned a password to access privilege level 8.
Line 3: The configure command is assigned to privilege level 8 because it needs to reach CONFIGURATION
mode where the snmp-server commands are located.
Line 4: The snmp-server commands, in CONFIGURATION mode, are assigned to privilege level 8.
Dell(conf)#username john privilege 8 password john
Dell(conf)#enable password level 8 notjohn
Dell(conf)#privilege exec level 8 configure
Dell(conf)#privilege config level 8 snmp-server
Dell(conf)#end
Dell#show running-config
Current Configuration ...
!
hostname Force10
!
enable password level 8 notjohn
enable password Force10
!
username admin password 0 admin
username john password 0 john privilege 8
!
The following example shows the Telnet session for user john. The show privilege command output
confirms that
john is in privilege level 8. In EXEC Privilege mode, john can access only the commands listed.
In CONFIGURATION mode, john can access only the snmp-server commands.
apollo% telnet 172.31.1.53
Trying 172.31.1.53...
Connected to 172.31.1.53.
Escape character is '^]'.
Login: john
Password:
Dell#show priv
Current privilege level is 8
Dell#?
configure Configuring from terminal
disable Turn off privileged commands
enable Turn on privileged commands
Security 913

Dell S4048T Specifications

General

Switching Capacity	1.44 Tbps
Rack Units	1U
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Optional
Product Type	Switch
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management Protocol	SNMP, RMON, Telnet, SSH
Features	Quality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)	17.3 in x 16 in x 1.7 in
Operating Temperature	0°C to 40 °C
Operating Humidity	10% to 90% (non-condensing)