EasyManua.ls Logo

Dell S4048T - Page 914

Dell S4048T
1277 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
exit Exit from the EXEC
no Negate a command
show Show running system information
terminal Set terminal line parameters
traceroute Trace route to destination
Dell#confi
Dell(conf)#?
end Exit from Configuration mode
exit Exit from Configuration mode
no Reset a command
snmp-server Modify SNMP parameters
Dell(conf)#
Specifying LINE Mode Password and Privilege
You can specify a password authentication of all users on different terminal lines.
The user’s privilege level is the same as the privilege level assigned to the terminal line, unless a more specific
privilege level is assigned to the user.
To specify a password for the terminal line, use the following commands.
Configure a custom privilege level for the terminal lines.
LINE mode
privilege level level
level level: The range is from 0 to 15. Levels 0, 1, and 15 are pre-configured. Levels 2 to 14 are
available for custom configuration.
Specify either a plain text or encrypted password.
LINE mode
password [encryption-type] password
Configure the following optional and required parameters:
encryption-type: Enter 0 for plain text or 7 for encrypted text.
password: Enter a text string up to 32 characters long.
To view the password configured for a terminal, use the show config command in LINE mode.
Enabling and Disabling Privilege Levels
To enable and disable privilege levels, use the following commands.
Set a user’s security level.
EXEC Privilege mode
enable or enable privilege-level
If you do not enter a privilege level, Dell Networking OS sets it to 15 by default.
Move to a lower privilege level.
EXEC Privilege mode
disable level-number
Security 914

Table of Contents

Related product manuals