Doremi IMS1000 - Playback Stops In-Between Clips

IMS.OM.002949.DRM Page 283 of 310 Version 1.4
Doremi Labs
PAR0_DDR: 49662EE0
BCR0_DDR: 00000000
WMK_CFG0: 00000000
WMK_CFG1: 00000000
ISR_DDR: 000000C5
ADV_CFG0: 00000000
ADV_CFG1: 00000000
ADV_CFG2: 0A0001EF
VID_CFG: 002814E0
VID_IER: 00000701
VID_IFR: 00000001
VID_CTRL: 00000000
AES_CONTROL: 00000004
AES_SIZE: 00000000
AES_PRESIZE: 00000000
CINELINK2_CONTROL: 00000000
WDG_CTRL: 00000000
MOB_TEMP: 00000000
VCLK_FREQ: 038A5FCD
FPGA_CAP: ADFFDF53
FPGA_2CAP: 00000008
MCORE_CAP: 5FFF0280
17.8.2.3 Solution
Install software version 2.5.5 or higher.
17.8.3 Playback Stops In-Between Clips
17.8.3.1 Description
The unit does not start playing, or stops playing on a clip-to-clip boundary.
17.8.3.2 Identification
When looking at \doremi\log\odetics.log (or \doremi\log\odetics.log.x if the issue occurred a
while before the report was taken), you should see the following message when this issue
occurs:
[Wed Nov 20 08:14:19 2013][INFO ]: Loading CPL '98781194-c4bc-3042-9b08-e81bd1ee3557'
in slot '1'...
[Wed Nov 20 08:14:19 2013][INFO ]: CPL '98781194-c4bc-3042-9b08-e81bd1ee3557'
successfully loaded
dolphin_video_context_internal(): Can't detect init ADVs done bit. Retrying...
dolphin_video_context_internal(): Can't detect init ADVs done bit. Too many failure!
[Wed Nov 20 08:14:34 2013][ERROR]: Can't set context to 'DolphinContextPaused'!
17.8.3.3 Solution
Update the firmware to version 4.2.7 or higher.