Doremi IMS1000 - Network Configuration; Changing the IP Address

IMS.OM.002949.DRM Page 86 of 310 Version 1.4
Doremi Labs
9 Network Configuration
9.1 Default Network Configuration
Ethernet port (Eth0) is set to DHCP by default. All IMS1000 boards are shipped from the factory
with the following default IP address for Eth1:
 IP: 192.168.100.50
 SM: 255.255.255.0
 GW: 192.168.100.1
9.2 Changing the IP Address
To change the IP address of the server, go to the Administration Tab → Control Panel →
Networking Configuration and then follow the steps below (Figure 95):
Figure 95: Networking Configuration Window
● The Networking Configuration window will appear. You will need to populate the
following fields:
○ Hostname
■ Note: It is a good idea to input the circuit location/screen number in here.
For example, “DoremiScreen-1,” as it will be easier to identify in the logs.
○ Properties of both eth0 & eth1:
■ IP Address
● Note: Do not put leading zeroes (0) in front of any numbers. For
example, do not input 192.168.100.050.
■ Netmask
■ Gateway
Revert
Button
Save
Button