IMS.OM.002949.DRM Page 53 of 310 Version 1.4
Doremi Labs
5 Installation and Marriage with a Barco Series-2
Projector
Before you begin to install the IMS1000 into your projector, be sure that:
o The projector is powered down and in the off position.
o Disconnect the AC power cord from the wall.
o Remember to always follow ESD procedures.
5.1 Preparation
Figure 42: Barco Projector
Remove the blank cover of the media block slot by unscrewing the two screws on the
sides (Figure 43).
To Next Page
Loading...
