DURKOPP ADLER 755 A

Programming
266 Service Instructions 755 A/756 A - 00.0 - 02/2019
Vacuum On/Off  p. 349
Downholder On/Off  p. 349
1.13 Select stacker/smoother  p. 349
Roll-off On/Off  p. 349
1.17 Select flap clamps  p. 350
1.18 Light barrier scan  p. 353
Waistband clamp On/Off  p. 350
1.20 Transport clamp adjustment  p. 350
Blow piping strips On/Off  p. 350
1.22 Select corner knife device  p. 350
1.23 Select pedal operation  p. 354
1.25 Toolbox configuration  p. 355
Zipper cutter On/Off  p. 350
Additional thread tension On/Off  p. 351
Shims On/Off  p. 351
Transport clamp pressure On/Off  p. 351
2.0 Machine test
2.1 Set and test hook thread monitor  p. 366
2.2 Test roll-off device  p. 367
2.3 Set and align light barriers  p. 368
2.4 Test corner knife position  p. 370
Set corner knife angle seam begin./seam end  p. 372
2.4.1 Adjust corner knife  p. 373
Set offset angle seam begin./seam end  p. 374
2.5 Set and test sewing motor  p. 376
Switch split needle bar On/Off  p. 376
2.5.1 Adjust sewing motor  p. 377
Set sewing motor position  p. 377
Set the maximum sewing motor speed  p. 377
2.5.2 Adjust sewing motor speed  p. 376
2.6 Test tape feeder  p. 364
2.7 Machine workflow test  p. 378
Menu item
Option/described
on page