Dynapac SD2500C - Page 103

D 11 17
Item Designation Brief description
30
Particulate filter
regeneration,
manual (o)
Detent switch function and LED feedback:
- for activating / manual trigger of particulate filter
regeneration.
A
Particulate filter regeneration does not start when the
soot level in the particulate filter is too low.
A
Particulate filter regeneration takes about 45 minutes.
31
Particulate filter
regeneration,
automatic -
deactivate (o)
Detent switch function and LED feedback:
- for deactivating the automatic trigger of particulate filter
regeneration.
A
Depending on the saturation level of the particulate
filter, automatic particular filter regeneration can take
place immediately after deactivation has been disabled.
32 not used
33
Extraction
ON / OFF (o)
Detent switch function and LED feedback:
- To actuate the asphalt fume control system
- Switch OFF by pressing the button again
34
Windscreen wip-
ers ON / OFF (o)
Detent switch function and LED feedback:
- For switching on the windscreen wipers
- Switch OFF by pressing the button again
35
Windscreen
washer system +
Windscreen wiper
ON / OFF (o)
Detent switch function and LED feedback:
- To actuate the windscreen washer system +
windscreen wipers
- Switched OFF with time control