D 11 39
Item Designation Brief description
64
Fill vehicle for paving
process
Detent switch function and LED feedback:
- Filling function for the paving process.
The diesel engine's speed is increased to the preselect-
ed nominal speed and all conveying functions set to "Au-
tomatic" (conveyor and auger) are engaged.
A
The main function switch must be set to the OFF po-
sition.
- Switch OFF by pressing the button again or by swiv-
elling the drive lever out to the paving position.
- On reaching the adjusted material height (material
sensor), the filling function is automatically switched
off.
f
On actuation, note danger zones of moving parts of
the vehicle!
65 Set-up mode
Detent switch function and LED feedback:
- When the vehicle is stationary, this function enables
all operating functions, which can only be activated
when the drive lever is swivelled out (vehicle driv-
ing), to be started up.
A
The main function switch must be set to the OFF po-
sition.
A
The engine speed is increased to the preselected
nominal value.
To Next Page
Loading...
