D 11 47
Item Designation Brief description
76
Indicator lamp
particulate filter
maintenance (o)
Lights up when particulate filter regeneration is necessary.
- Indicator lamp on all the time: Urgent maintenance, level I.
Particulate filter regeneration must be carried out as soon
as the operating status of the machine permits.
- Indicator light flashes: Urgent maintenance, level II.
Particular filter regeneration must be carried out as soon as
possible.
- Indicator light flashes + indicator light "Engine malfunction"
(85) is on all the time. Urgent maintenance, level III.
Particulate filter regeneration is vitally necessary to avoid
subsequent damage and repairs.
- Indicator light goes off + indicator light "Engine malfunction"
(78) is on all the time. Particulate filter regeneration is no
longer possible.
m
Operation must be stopped immediately.
A
Consult the Dynapac Service Department.
77
Indicator lamp
particulate filter
regeneration,
automatic -
deactivated (o)
Lights up when particulate filter regeneration is deactivated.
A
Automatic regeneration should only be deactivated if
the operating status of the paver finisher does not
permit any automatic function.
78
Error message
"Serious error"
(red)
Lights up when a serious error has occurred on the engine.
m
Switch off the drive engine immediately!
A
The error code can be called up using the switch
"Call up error / malfunction".
A
Lights up for a few seconds once the ignition has been
switched on for checking purposes.
79
Indicator lamp
Engine coolant
temperature
Lights up when the engine temperature is too high.
m
The engine performance will be throttled down automat-
ically. (Driving mode remains possible). Stop the paver
finisher (drive lever to the centre position), let the engine
cool down while idling. Determine the cause and rectify
if necessary (refer to "Malfunctions" section). After cool-
ing down to normal temperature, the engine will run with
full performance again.
A
Indicates the fault together with the "Error message"
lamp.