Dynapac SD2500C User Manual

D 11 57
Item Designation Brief description
122
Auger
"MANUAL"
Button with detent switch function and LED feedback:
- The conveying function of the corresponding half of
the auger is switched on continuously with full deliv-
ery capacity, without material control via the limit
switches.
- Switch OFF by pressing the button again
A
The function is shut off by pressing the EMERGENCY
STOP button or restarting the vehicle.
A
The main function switch locks the conveying function.
123
Auger
"AUTO"
Button with detent switch function and LED feedback:
- The conveying function of the corresponding half of
the auger is switched on when the drive lever is swiv-
elled out and is continuously controlled via the mate-
rial limit switches.
- Switch OFF by pressing the button again
A
The function is shut off by pressing the EMERGENCY
STOP button or restarting the vehicle.
A
The main function switch (operating panel) locks the
conveying function.
124
Auger
"Reversing mode"
Pushbutton function:
- The auger's conveying direction can be reversed in
order to slightly reverse any paving material which
may be positioned just in front of the auger. This en-
ables e.g. material losses to be avoided during trans-
portation.
- Temporally limited reversal is carried out when the
button is pressed continuously.
A
The auger function must be switched to "AUTO" or
"MANUAL" for reversing mode.
A
In reversing mode, the automatic function is overridden
with reduced capacity.

Dynapac SD2500C Specifications

General

Brand	Dynapac
Model	SD2500C
Category	Construction Equipment
Language	English