E 10 62
m
Attachment and loading equipment must meet the conditions of the applicable acci-
dent prevention regulations!
m
Heed the bucket's centre of gravity during loading!
m
Clean bucket before loading, remove material residues!
A
Use the securing points (1, 2) provided on the binder course hopper for loading with
the lifting gear.
A
The centre of gravity of the bucket is in the area marked (3).
- Attach lifting gear to the attachment points (1, 2).
A
(A) Loading example bucket MH2500 - short version
m
The max. permissible attachment point load at the attachment points is: 44kN.
A
(B) Loading example bucket MH2550 - long version
m
The max. permissible attachment point load at the attachment points is: 150kN.
Danger from suspended loads
Crane and/or lifted load can tip when lifted and
cause injuries!
- The load may only be raised at the marked lifting points.
- Do not enter the danger zone.
- Use only lifting gear that can bear the load.
- Do not leave any material residues or loose parts in
the bucket.
- Comply with all further information in these instructions
and in the safety manual.
To Next Page
Loading...
