E 10 64
A
The following explanations for securing the bucket in the paver act as examples for
correct usage in a Dynapac paver finisher.
When combining different brands, the bucket must be secured according to the avail-
able possibilities.
A
Dynapac does not assume any warranty for damage caused by the bucket being in-
correctly secured!
m
The paver finisher must have the necessary number of lashing points with a lashing
strength of LC 5.000 daN.
m
The ends of lashing chains and straps must be secured to prevent them working
loose and falling down unintentionally!
m
Clean bucket and paver hopper before inserting the bucket, remove material residues.
Removing adhering material residues from contact surfaces.
m
The bucket is secured by tying it down,
using the lashing points (1) on the bucket.
Fasten the lashing straps to the drive unit frame (2) of the paver finisher as shown.
m
The bucket is secured at the front by diagonal lashing, using the lashing points (3) on
the bucket and the towing eye (4) on the paver finisher.
Fasten the lashing straps as shown.
A
Fasten the lashing straps diagonally to the bucket and to the towing eye on the
paver finisher.
To Next Page
Loading...
Need help?
General
