F 54 10
- Position a collecting container be-
neath the oil pan oil drain screw (E).
- Remove the oil drain screw (E) and al-
low the oil to drain completely.
- Reinstall the oil drain screw (E) with a
new seal and tighten properly.
- Fill in the specified quality of oil
through the filler opening (B) on the
engine until the oil level rises to the
correct mark on the dipstick (A).
A
When fitted with the optional asphalt
fume control system, there is a drainage
hose behind the left side flap.
- Place the end of the oil drain port hose
(E1) in the collection container.
- Remove the screw cap with a wrench
and allow the oil to drain completely.
- Replace the screw cap and tighten
properly.
- Refill with oil as described above.
Changing the oil filter:
A
All filters are accessed via the service
flap (F) on the vehicle's centre wall:
- Remove the screws (G) from the inner
side of the frame and remove the serv-
ice flap (F).
- After completing the maintenance
work, reinstall the service flap (F)
properly.
To Next Page
Loading...
