6
E10 Set-up and modification ......................................................... 1
1 Special notes on safety ..............................................................................1
2 Distribution auger .......................................................................................2
2.1 Height adjustment ......................................................................................2
Grain sizes up to 16 mm ........................................................................2
Grain sizes > 16 mm ..............................................................................2
2.2 Mechanical adjustment with ratchet (o) ......................................................3
2.3 Hydraulic adjustment (o) ............................................................................3
2.4 Height adjustment for large working widths / with brace ............................4
3 Auger extension .........................................................................................6
3.1 Mounting extension parts ...........................................................................7
Mounting the material shaft and auger extension ..................................7
Mounting the outer auger bearing ..........................................................8
Mounting the auger end bearing ............................................................9
3.2 Auger extension chart ..............................................................................10
Auger upgrading, working width 3.14 m ...............................................12
Auger upgrading, working width 3.78 m ...............................................12
Auger upgrading, working width 4.42 m ...............................................12
Auger upgrading, working width 5.06 m ...............................................13
Auger upgrading, working width 5.70 m ...............................................13
Auger upgrading, working width 6.34 m ...............................................14
Auger upgrading, working width 6.98 m ...............................................15
Auger upgrading, working width 7.62 m ...............................................16
Auger upgrading, working width 8.26 m ...............................................17
Auger upgrading, working width 8.90 m ...............................................18
3.3 Mounting the auger brace ........................................................................19
3.4 Aligning the auger ....................................................................................21
3.5 Material shaft, hinged ...............................................................................22
3.6 Hopper scraper .........................................................................................23
3.7 Crossbeam guide .....................................................................................24
4 Offsetting the screed ................................................................................25
5 Levelling ...................................................................................................26
5.1 Slope controller ........................................................................................26
5.2 Mounting the sensor arm ..........................................................................27
5.3 Mounting the grade control system ..........................................................27
5.4 Setting up the sensor arm ........................................................................28
5.5 Big ski 9 m, big ski 13 m ..........................................................................29
Mounting the big ski bracket on the crossbeam ...................................31
Mounting the swivel arms .....................................................................32
Mounting the centre element ................................................................33
Extending the big ski ............................................................................34
Mounting the sensor bracket ................................................................35
Mounting and aligning the sensors ......................................................36
Mounting the distributor box .................................................................37
Connection diagram .............................................................................38
5.6 Levelling shoe 6m, 9m ............................................................................39
6 Automatic steering unit .............................................................................41
6.1 Mounting the automatic steering unit on the paver finisher ......................42
Mounting and aligning the sensor ........................................................43
To Next Page
Loading...
