4. Pick up the handset.
If a message to start sending or receiving faxes is displayed as shown on the following screen, the connection
has been established.
Related Information
& “Making the Printer Ready to Send and Receive Faxes” on page 120
& “Making Settings to Use an Answering Machine” on page 123
& “Making Settings to Receive Faxes Operating Only a Connected Phone” on page 123
& “Receive Mode:” on page 378
Making the Printer Ready to Send and Receive Faxes
Fax Setting Wizard congures the basic fax features to make the printer ready to send and receive faxes.
e Wizard is displayed automatically when the printer is turned on for the rst time. You can also display the
wizard manually from the printer's control panel. You need to run the wizard again in case the wizard is skipped
when the printer is rst turned on or when the connection environment has changed.
❏ e items below are what you can set through the wizard.
❏ Header (Your Phone Number and Fax Header)
❏ Receive Mode (Auto or Manual)
❏ Distinctive Ring Detection (DRD) Setting
❏ e items below are set automatically according to the connection environment.
❏ Dial Mode (such as Ton e or Pulse)
Fax Setting Wizard may not congure Dial Mode automatically when Line Type is set to PBX. Congure
Dial Mode manually.
❏ Other items in Basic Settings remain as they are.
Related Information
& “Basic Settings” on page 377
Making the Printer Ready to Send and Receive Faxes Using Fax Setting Wizard
1. Select Settings on the home screen on the printer's control panel.
Preparing the Printer and Making Initial Settings
>
Settings for Printing, Scanning, Copying and F
…
120
To Next Page
Loading...
Need help?
General
