Error Code
439
Problem Solving
14
027-772
O [Cause] An error occurred during communication with the SMTP
server.
[Remedy] Use ASCII characters to modify the host name that has
been specified under [Tools] > [System Settings] >
[Connectivity & Network Setup] > [Machine’s E-mail
Address/Host Name]. If the error persists, check with your
network administrator whether the SMTP server supports
the HELO command.
027-773
O [Cause] An error occurred during communication with the SMTP
server.
[Remedy] Wait for a while, and try again.
027-774
O [Cause] The specified e-mail address contains unsupported
characters.
[Remedy] Specify the e-mail address using ASCII characters.
027-775
O [Cause] Too many destination addresses have been specified.
[Remedy] Reduce the number of destination addresses. If the error
persists, check with your network administrator whether
the SMTP server supports the EHLO command.
027-776
O [Cause] An error occurred during communication with the SMTP
server.
[Remedy] Use ASCII characters to modify the host name that has
been specified under [Tools] > [System Settings] >
[Connectivity & Network Setup] > [Machine’s E-mail
Address/Host Name]. If the error persists, check with your
network administrator whether the SMTP server supports
the EHLO command.
027-777
O [Cause] The destination SMTP server does not support SMTP-
AUTH.
[Remedy] Set [E-mail Send Authentication] to [Off] under [Tools] >
[System Settings] > [Connectivity & Network Setup] >
[Outgoing/Incoming E-mail Settings] > [SMTP Server
Settings].
027-778
O [Cause] The destination SMTP server does not support the SMTP-
AUTH system.
[Remedy] Check with your network administrator about the
authentication type supported by the SMTP server. The
machine supports the following authentication types:
PLAIN (plain text) authentication, LOGIN (BASE64)
authentication, and CRAM-MD5 (challenge-response).
027-779
O [Cause] Failed to authenticate the SMTP server.
[Remedy] Check the login name and password set to SMTP-AUTH.
027-796
O O O [Cause] The received e-mail was discarded because it had no
attached documents. (The machine is set to print attached
documents only.)
[Remedy] To also print the mail body or header information, change
settings in the Properties screen of CentreWare Internet
Services.
Refer to "12 Computer Operations" > "E-mail Printing" in the User Guide.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
