27. Conning Display
27-3
27.2.1 ROT window
The ROT window monitors actual ROT, which is displayed in digital format in
the upper center box and analog format in the center of the window. The text
CALC" appears when ROT is calculated by the system. The scale is available
from 35 to 90 degrees, and is set at installation, with installation parameters. For
further details, see Chapter 19 Navigation Sensors.
27.2.2 Heading window
:
The heading window shows the following information:
• Gyro course, both in digital and analog formats.
• Diamond figure shows heading in graphical format.
For further details, see Chapter 19 Navigation Sensors.
27.2.3 Speed window
The speed window shows the following information:
• Bow speed
• Longitudinal speed
• Stern speed
• Direction of true wind relative to your ship. (True wind must be chosen on
the menu to get true wind.)
• Source of speed indicator (BOTTOM in example)
This window shows center speed, single speed readout.
For further details, see Chapter 19 Navigation Sensors.
Speed window shows speed trough water (SPD) and Speed Over Ground SOG
Source of SPD is shown upper left corner and source of SOG is shown upper
right corner.
This window shows center speed, dual speed readout.
Note: There are two different sizes in the vertical direction for the Speed
window. The size of the Speed window depends on of Rudder window selected.
For how to set the speed window, see the installation manual.
To Next Page
Loading...
