28. Steering with FURUNO Autopilot FAP-2000
28-4
9: Autopilot FAP-2000 status indicator: Shows chosen mode and state of readiness.
• Autopilot FAP-2000 in operation: READY
• Autopilot FAP-2000 control mode: HEADING/TRACK
• Autopilot FAP-2000 automatic route steering: ROUTE
• Autopilot FAP-2000 track controlled turn: TURN
10: Autopilot FAP-2000 alarm indicator and buzzer cancel
• ALARM lamp for other Autopilot FAP-2000-related alarms and errors
• RESET button for acknowledging other Autopilot FAP-2000-related alarms and errors.
11: Special function keypad
• Select manual speed
• Adjust panel dimmer
• Set manual speed value, auto speed, rudder limit function, performance and conditions.
12: Tiller
• Set course and radius.
• PORT and STBD lamps show when the tiller can be used to set course.
• INCREASE. and DECREASE. lamps show when the tiller can be used to set a radius or a rudder angle
limit.
13: Gyro reading and a bar graph showing rate of turn
14: Set Heading display includes:
• Off course alarm
• Turn side
• Rudder-on limit indication
15: Displays:
• Radius set-point in Radius Control mode
• Rudder limit in Heading Control mode
• AUTO LIMIT lamp lights to indicate selection of automatic rudder limit function.
16: Displays:
• ROT in Radius Control mode
• Speed in Heading Control mode
• Speed warning indicator (LOG FAILURE or LOW)
To Next Page
