30. Steering With TOKYO KEIKI Autopilot PR-6000
30-6
NFU override controller
Starting override steering:
1. Confirm that the Ready lamp in the NFU
controller is ON.
2. Pull out the pin stopper inserted in the
override NFU controller and turn the lever to
the desired direction. At this time, beeps
sounds from the steering stand then the
selected steering mode blinks. The ON lamp
in the override reset unit is lit.
3. The rudder is taken when the lever is turned,
and the rudder stops when the lever is
returned to the neutral position.
Stopping override steering:
1. Push the RESET switch on the override
reset unit in the steering stand to return to the
previous steering mode.
2. If the steering mode was AUTO, the heading
at the time the override steering became
active is set as heading. Auto resume is
disabled if the steering mode was RC/NAV.
In this case, you have to turn the mode
selection switch to the other steering mode
and select the RC mode again.
Ready lamp
Override steering level
Pin stopper
Override indicator
Override steering
reset switch
Dimmer knob
NFU override controller
To Next Page
