EasyManuals Logo

General Dynamics 7200 User Manual

General Dynamics 7200
252 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #179 background imageLoading...
Page #179 background image
7200 PASSWORD PROTECTION
B - 3
19. On the rear of the 7200 ACU, set the power switch to the on position.
20. Verify that the only fault showing is DRIVE DISABLED (LOW SIGNAL may also
be displayed).
21. Verify that the resolver readout is steady.
22. Press the DRIVE ENABLE switch so that the drives are enabled.
23. Verify that all faults are cleared, with the possible exception of a low signal
level.
24. On the rear of the 7200 ACU, set the power switch to the off position.
25. Holding the top left corner of the cover with one hand, press the hinge in with
the other hand and lower the cover until it seats on top of the unit. Reinsert
and tighten the two #6-32 screws that secure the cover.
26. Slide the 7200 ACU back into position and secure the front panel to the rack
with four #10-32 screws.
27. On the rear of the 7200 ACU set the power switch to the on position. Verify
that password protection has been set correctly.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the General Dynamics 7200 and is the answer not in the manual?

General Dynamics 7200 Specifications

General IconGeneral
BrandGeneral Dynamics
Model7200
CategoryControl Systems
LanguageEnglish