115
Program description - Stick mode | Winged models
After selecting the "Tr. step" column (trim steps) and
the desired trim control with the selection keys
of the left or right touch pad, the corresponding entry
field will be framed.
global
Channel 1
Aileron
Elevator
Rudder
Tr i m
0.0s
Tr. step – time +
global
0.0s
Phase
0.0s
global
0.0s
0.0s
0.0s
0.0s
0.0s
4
4
4
4
Briefly tap the centre SET key of the right touch pad.
The current setting will be displayed in inverse video.
Now select the desired value, between 1 and 10, with
the selection keys of the right touch pad. For example:
global
Channel 1
Aileron
Elevator
Rudder
Tr i m
0.0s
Tr. step – time +
global
0.0s
Phase
0.0s
global
0.0s
0.0s
0.0s
0.0s
0.0s
4
4
8
4
A simultaneous tap on the or keys of the
right touch pad (CLEAR) will reset any change made
to the active field back to "4".
Important notice:
Use safety reasons by no means the
“Auto trim” from the menu “Basic
adjustment model” (page 91) at a
setting of “0” trim steps.
Time
The rate of control signal change with respect to the
speed of stick motion can be influenced by the entries
made in the "– time +" column. Each stick movement
direction, i. e. stick control channels 1 through 4, can
be set individually. This means that respective servos
will then follow rapid control position changes only
at an accordingly delayed rate. This time delay has a
direct effect on the control function and therefore also
any servos controlled by this function.
The time can be programmed symmetrically for both
sides or separate for each control direction. This
setting has a programmable range of 0 s to 9.9 s. In
the case of side-separate settings, the stick is to be
moved to the respective side so that the inverse video
field will switch between sides to the one for which the
change is to be made – for example, even to ensure
gentle rev-up of the propulsion motor despite a (too)
fast motion of the C1 stick.
global
Channel 1
Aileron
Elevator
Rudder
Tr i m
1.1s
Tr. step – time +
global
0.0s
Phase
0.0s
global
0.0s
0.0s
0.0s
0.0s
0.0s
4
4
8
4
On the other hand, for reasons of safety, the motor
cut-off should always be "immediate".
A simultaneous tap on the or keys of the
right touch pad (CLEAR) will reset any change made
to the active field back to "0.0 s".
To Next Page
Loading...
