275
Program description - Basic settings
Use the selection keys on the left or right touch pad
to scroll to the »Basic settings« menu option in the
multi-function menu:
Dual mixer
Fail-safe adjust
Teacher / pupil Tx. output swap
Profi trim
Trim memory
Telemetry Channel sequence
Multichannel Ring limiter
Mp3 player
Basic settings
Swashplate mixer Fail-safe adjust
Teacher / pupil Tx. output swapg
Profi trim
Trim memeory
Telemetry Channel sequence
Multichannel Ring limiter
Mp3 player
Basic settings
Tap briefly on the centre SET key of the right touch
pad to open this menu option:
Battery type
Battery warning
Touch Sense
Top LCD Contrast
Li-Io
Display light
2
3.60V
0
unlim.
GENERAL BASIC SETTINGS
Owners name
H-J Sandbrunner
Pre-set stick mode
1
Pre-set DSC Output
PPM10
Pre-set Pitch min
rear
Stick warning:
unlim.
Pre-set modulation
Own phase name
Own phase name
HoTT
2
10
Bottom LCD Contrast
0
Own phase name
1
Voice volume
Vario volume
Touch-beeps vol.
7
fr –––
SEL SEL
7
fr –––
7
fr –––
Power-on/off beep yes
Bluetooth headset
off
BT ID connection
off
BT speaker
0
0/0
DATA sel
telemetry
Basic settings are made in this menu. Transmitter-
specific settings, such as volume regulation for
acoustic signals and voice messages output via the
built-in speaker or headset connector, the owner's
name, country setting and even specifications for new
model memories. The settings made in this menu on
the lines …
• "Pre-set stick mode",
• "Pre-set modulation",
• "Pre-set DSC Output" and
• "Pre-set Pitch min"
… therefore have no influence whatsoever on already
existing model memories; instead, they are only
defaults which are automatically adopted into newly
initialized model memories and can be changed
there individually at any time in the »Basic settings,
model« and »Helicopter type« menus. A change
to the "Pre-set" settings in value fields of this menu
therefore only affects those model memories created
new at a later time.
Note:
The settings in this menu are only specied
once in the entire transmitter. Therefore, after
opening this menu in another model memory,
the last valid settings always appear.
Select the desired line with the selection keys
of the left or right touch pad then tap the centre SET
key of the right touch pad. The value in the field now
displayed in inverse video can be changed. After a
change has been made, the entry can be concluded
with another tap on the centre SET key of the right
touch pad or the centre ESC key of the left touch pad.
Voice volume / Vario volume / Touch-beeps vol.
H-J Sandbrunner
GENERAL BASIC SETTINGS
Owners name
Voice volume
Vario volume
Touch-beeps vol.
7 fr –––
7
fr
–––
7
fr –––
SEL SEL
These three lines can be used to individually set the
volume of the three groups of acoustic signals and
Basic settings
Basic transmitter settings
To Next Page
Loading...
