75
Program description - Copy / Erase
Copy model model
Select the “Copy model model” sub-menu with the
selection keys of the left or right touch pad then
tap the SET key.
Copy flight en kopieren
Erase model
Copy modelodell –> Modell
Export to SD-Karte
Import fromn von SD-Karte
=>
OFFON
Please select
RF on/off?
If the message shown above should appear, the
transmitter's RF module is still active.
By pressing the central ESC button of the left or the
centre SET key of the right touch pad to cancel the
operation.
Choose contrast with the button left or right touch
pad to “OFF” and confirm your choice with a brief tap
on the SET key, the process continues. Safety, turn
off but before a possibly in operation receiving sys-
tem.
Choose the model to be copied with the selection
keys of the left or right touch pad …
03
04
05
01
free
01:23hR16
Ultimate
02
Graubele
1234g/080811
00:44hR12
Starlet
BELL47G
00:33hR08
00:22hR08
Test
trim needed
Copy from model:
… then, following the change into the "Copy to model"
window caused by another tap on the SET key of the
right touch pad, the destination memory can be se-
lected with the selection keys of the left or right
touch pad.
Yet another tap on the SET key will then confirm the
copy process or a tap on ESC key will cause the copy
to be cancelled. A memory location which is already
occupied can be overwritten.
03
04
01
01:23hR16
Ultimate
02
Graubele
1234g/080811
00:44hR12
Starlet
BELL47G
00:33hR08
00:22hR08
Test
trim needed
Copy to model:
free
05
After confirming the selected model memory with a
tap on the SET key, a confirmation request will ap-
pear:
Model really
Ultimate
to be copied?
NO
YES
02
05
free
A NO response will cancel the process and return
the screen to the originating screen. If the YES
response is selected and confirmed with a tap on the
SET key then the selected source model will be cop-
ied into the selected model memory destination.
Note:
In addition to model data, binding data is also
copied by this process. This means that a
receiver system which was/is bound to the
original model memory can also be operated by its
copy in the SAME transmitter without establishing the
binding again.
Exporting to SD card
Use the selection keys of the left or right touch
pad to select the “Export to SD” sub-menu then tap
on the SET key.
Copy flight sen kopieren
Erase model
Copy modeModell –> Modell
Export to SDach SD-Karte
Import from von SD-Karte
=>
OFFON
Please select
RF on/off?
If the message shown above should appear, the trans-
mitter's RF module is still active.
By pressing the central ESC button of the left or the
centre SET key of the right touch pad to cancel the
operation.
Choose contrast with the button left or right touch
pad to “OFF” and confirm your choice with a brief tap
on the SET key, the process continues. Safety, turn
off but before a possibly in operation receiving sys-
tem.
Choose the model to be exported with the selec-
tion keys of the left or right touch pad …
03
04
05
01
free
01:23hR16
Ultimate
02
Graubele
1234g/080811
00:44hR12
Starlet
BELL47G
00:33hR08
00:22hR08
Test
trim needed
export to SD-Card:
After confirming the selected model memory with a tap
on the SET key, a confirmation request will appear:
To Next Page
Loading...
