81
Programmbeschreibung - Modelle ausblenden
Suppress models
Suppression of model memory locations
Use the selection keys of the left or right touch
pad to select the »Suppress models« menu …
Model select
Servo adjustment
Stick mode
Control adjust
Dual Rate / Expo
Channel 1 curve
Switch display
Copy / Erase
Suppress codes
Suppress models
Base setup model
Model type
Model select
Servo adjustment
Stick mode
Control adjust
Dual Rate / Expo
Channel 1 curve
Switch display
Copy / Erase
Suppress codes
Suppress Models
Base setup model
Helicopter type
… then briefly tap the centre SET key of the right
touch pad.
Model memories which are rarely needed or to which
access is to be blocked for other reasons can be hid-
den from the model selection list. This also clarifies
the overview layout for model selection.
The model to be suppressed/displayed is selected
with the selection keys of the left or right touch pad
then its status is switched over with a tap on the cen-
tre SET key of the right touch pad.
03
04
05
01
free
01:23hR16
Ultimate
02
Graubele
1234g/080811
00:44hR12
Starlet
BELL47G
00:33hR08
00:22hR08
Test
trim needed
Suppress :
SET
A model memory which is "stricken through" will no
longer appear in the »Model select« menu.
03
04
Starlet
BELL47G
00:33hR08
00:22hR08
trim needed
free
free
05
06
01
01:23hR16Graubele
1234g/080811
free
07
To Next Page
Loading...
