GRAUPNER mc-32

238
Program description - Pro trim | Helicopter models
Pro trim
Pitch, throttle, tail-rotor, and C1 curve trimming
The mc-32 HoTT transmitter's software has an
integrated function for additional trimming of 8-point
curves; in Heli programs »Channel 1 curve« page
143, and »Helicopter mixer« page 190. These are
intended for "Pitch" curves "Channel 1  Throttle"
and "Channel 1  Tail. rot.".
This feature, named »Pro trim« because of its
functional similarity to the Profi-Trim module for the
mc-24 but only available on that transmitter as a ret-
rofit option. Select this feature from the multi-function
menu with the selection keys of the left or right touch
pad …
Fl. phase timers
Helicopter mixer
Free mixer
MIX active/phase
MIX-only channel Dual mixer
Swashplate mixer Fail-safe adjust
Teacher / pupil Tx. output swap
Profi trim
Trim memory
… then open this menu option with a brief tap on the
centre SET key of the right touch pad.
Mixer
Point Phase
free
free
free
free
None
None
None
None
L 1
1
1
1
L
L
L
"Trim control" column
Note:
Pay attention to potential double-assignments
when making trim control choices.
This menu's first line is for assigning those transmitter
controls (from the many available on the transmitter)
which appear most advantageous for this purpose.
To assign a transmitter control, use the selection keys
to navigate to the desired line then tap briefly on the
centre SET key of the right touch pad …
Mixer
Point Phase
free
free
free
free
None
keiner
keiner
None
L 1
1
1
1
L
L
L
Move desired
control adj.
… then move the desired transmitter control:
Mixer
Point Phase
Slide1
free
free
free
None
None
None
None
L 1
1
1
1
L
L
L
Erase trim control
Select the transmitter control assignment in the ap-
propriate line as already described, e. g.:
Mixer
Point Phase
Slide1
free
free
free
None
keiner
keiner
None
L 1
1
1
1
L
L
L
Move desired
control adj.
A tap, at the same time, on the  or  selection
keys of the right touch pad (CLEAR) will now reset
the field's value back to "free".
"Mixer" column
This column contains a total of four Value fields, in
which you can select one of the helicopter mixers
from a list, either individually or in any combination.
To do this, use the selection keys on the left or right
touch pad to change to the desired value field. Then
briefly tap the centre SET key of the right touch pad …
Mixer
Point Phase
Slide1
free
free
free
None
None
None
L 1
1
1
1
None
L
L
L
… and select the desired mixer with the selection
keys of the left or right touch pad: