74
Program description - Copy / Erase
Model really
Ultimate
to be erased?
NO
YES
02
… to appear. A NO response will cause the process
to be cancelled and a return to the previous screen.
Selecting the YES response with the selection key
of the left or right touch pad followed by confirmation
of the selection with a brief tap on the SET key will
erase the selected model memory.
This erase process cannot be
undone. All data in the selected
model memory will be erased
completely.
Note:
If the currently active model memory is to be
erased, a model type "Winged" or "Heli" must
be dened immediately after the erase
process. You cannot avoid this selection even if you
switch the transmitter off. Only afterward the
undesired occupation of that model memory erase
from another memory location.
If, however, an inactive memory location is erased,
it will subsequently appear in "Model select" list as
"free".
If the message shown above should appear, the
transmitter’s RF module is still active.
By pressing the central ESC button of the left or the
centre SET key of the right touch pad to cancel the
operation.
Choose contrast with the button left or right touch
pad to “OFF” and confirm your choice with a brief tap
on the SET key, the process continues. Safety, turn
off but before a possibly in operation receiving sys-
tem.
Copy flight phase
Erase model
Copy model –> model
Export to SD
Import from SD
=>
Tap to open the submenu, briefly press the central
SET button of the right touch pad.
Choose the model to be erased with the selec-
tion keys of the left or right touch pad …
03
04
01
01:23hR16
Ultimate
02
Graubele
1234g/080811
00:44hR12
Starlet
BELL47G
00:33hR08
00:22hR08
Test
trim needed
Select model to be erased :
… whereby another tap on the SET key will cause the
confirmation request …
Copy / Erase
Erase model, copy model model, copy from or to SD card, copy flight phases, store/cancel changes
Use the selection keys of the left or right touch
pad to select the »Copy / Erase« menu …
Servo adjustment
Stick mode
Control adjust
Dual Rate / Expo
Channel 1 curve
Switch display
Model select
Copy / Erase
Suppress codes
Suppress models
Base setup model
Model type
Servo adjustment
Stick mode
Control adjust
Dual Rate / Expo
Channel 1 curve
Switch display
Model select
Copy / Erase
Suppress codes
Suppress models
Base setup model
Helicopter type
… then briefly tap the centre SET key of the right
touch pad.
Erase model
Select the “Erase model” sub-menu with the se-
lection keys of the left or right touch pad then briefly
tap on the SET key.
Copy flight en kopieren
Erase model
Copy modelodell –> Modell
Export to SD-Karte
Import fromn von SD-Karte
=>
OFFON
Please select
RF on/off?
To Next Page
Loading...
