51
Für Ihre Notizen
Restoring the transmitter software
If a firmware update of the station have failed, or the
transmitter software “hang” and allows the transmitter
may also no longer on the “POWER” switch off, then
please disconnect the transmitter battery connector
and plug it after a few seconds.
Leave the transmitter off!
Download in this case download an actual software
package from the Internet and unzip it on your PC or
Laptop and if you have already done this, restart the
PC program gr_Studio and follow the details of the
section “restore” following the instructions contained
in the software package.
To Next Page
Loading...
