92
Program description - Base setup models | Winged models
Auto timer reset
BASIC SETTING,MODEL
SET SET
Power on warning L1
Auto trim –––
ext. PPM signal normal
SEL
Auto timer reset yes
The "yes/no" setting made in this line determines
whether or not all of the transmitter's timers (except
for "Model time" (see page 165) and "Transmitter
operating time") are automatically reset to their given
starting values when the transmitter is switched on.
A simultaneous tap on the or keys of the right
touch pad (CLEAR) will reset the display to "yes".
Before programming specific parameters, there are
some basic settings to be made which effect the cur-
rently active model memory.
Use the selection keys of the left or right touch pad to
select the »Base setup model« menu …
Model select
Servo adjustment
Stick mode
Control adjust
Dual Rate / Expo
Channel 1 curve
Switch display
Copy / Erase
Suppress codes
Suppress models
Base setup model
Helicopter type
… then tap the centre SET key of the right touch pad.
Model name
Model name
Stick mode
1
n/a
BASIC SETTINGS,MODEL
Info
n/a
n/a
Module
bind
HoTT
Change to the next screen page with a brief tap on
the SET key of the right touch pad. This will open a
screen of characters for entry of the model's name.
A maximum of 13 characters can be used to specify
a model name.
!"#$%&’()
Model name
Starle
@ACDEFGHIJKLMNOPQRSTUVWXYZ[¥]^_
?+,–./0123456789:;
¢ÇüéâäàåçêëèïîìÄÅÉæÆôöòûùÖÜ
`abcdefghijklmnopqrstuvwxyz{|}~
Now the desired characters can be selected with the
selection keys of the left touch pad. Move to the next
position to select the next character with a tap on
the of the right touch pad or its centre SET key. A
simultaneous tap on the or keys of the right
touch pad (CLEAR) will place a space character at
the current position.
Positioning to any character position within the entry
field can be done with the keys of the right touch
pad.
A return to the previous menu screen is accomplished
with a tap on the centre ESC key of the left touch pad.
A model name entered in this manner will appear in
the base screen of the »Model select« menu and in
the sub-menus of the »Copy / Erase« menu item.
Info
Model name
Stick mode
1
n/a
BASIC SETTINGS,MODEL
Info
n/a
n/a
Module
bind
HoTT
Starlet
Every model can be given a supplementary note of
up to 12 characters (maximum) by following the same
procedure as already described for creating a "Model
name".
Base setup model
Model-specific base settings for helicopter models
To Next Page
Loading...
