GRAUPNER mc-32

260
Program description - Telemetry
After selection of the desired menu line with the 
selection keys of the left or right touch pad …
TELEMETRY
SETTING & DATAVIEW
SENSOR SELECT
RF STATUS VIEW
VOICE TRIGGER
TELEMETRY RCV
BIND. 1
VOLT.E
… and a subsequent tap on the centre SET key of the
right touch pad will open the selected sub-menu:
Firmware version V1101 and lower
VOICE TRIGGER
REPEAT
TRIG
TRANSMIT
–––
–––
VARIO
–––
10sec
RECEIVER
GENERAL MODUL
ELECTRIC AIR.MOD
VARIO
GPS
AIR ESC
Note:
• Independently by the rmware version
the sensors displayed by your transmitter
here vary according to the information
you have entered in the “SELECT SENSOR”
sub-menu; see page 258.
• The screen-shot above shows the maximum
number of options, corresponding to “all sensors
selected”.
Firmware version V1102 and higher
VOICE TRIGGER
REPEAT
TRIG
TRANSMIT
–––
–––
VARIO
–––
10sec
RECEIVER
VARIO
REPEAT
VOICE TRIGGER
REPEAT
TRIG
TRANSMIT
–––
–––
VARIO
–––
10sec
VARIO
In order to be able to start the voice output through
the headphone connection, at the very least the "RE-
PEAT" line must be assigned to a switch. The takes
place as described in the section "Switch and control
switch assignments" on page 60:
VOICE TRIGGER
REPEAT
TRIG
TRANSMIT
–––
–––
VARIO
–––
1SEC
Move desired switch
to ON position
(ext. switch: ENTER)
VOICE TRIGGER
REPEAT
TRIG
TRANSMIT
–––
VARIO
–––
10sec
3
VARIO
With this switch you can have the last respective
voice trigger repeated for the duration of the time
set to the left of the switch, as long as the assigned
switch is closed.
Simultaneously pressing the Select buttons  or
 of the right-hand four-way button (CLEAR) resets
the time value to “1 SEC.”.
TRIG
With a switch assigned to this line, preferably one of
the two pushbuttons, switch the selected voice mes-
sages in rotation on to the next voice message for the
below-described "TRANSMITTER", "RECEIVER" and
"SENSOR" options, as described below.
VOICE TRIGGER
REPEAT
TRIG
TRANSMIT
VARIO
–––
10sec
3
1
VARIO
VARIO
Firmware version V1101 and lower
If the "VARIO MODULE" line is activated (
) in the
»SENSOR SELECT« sub-menu, a switch assigned to
one of these lines can be used to call up vario-specif-
ic voice messages for the headset connection which
are completely independent of other voice messages,
VOICE TRIGGER