76
Program description - Copy / Erase
On the other hand, if a "nameless" model is
exported, its data will be stored on the memory
card under "ahNoName.mdl" or "hNoName.mdl",
as appropriate.
• Some special characters that can be used in
model names are subject to speci c restrictions
associated with the FAT or FAT32 le system
used by the memory cards and these special
characters will be replaced during the copy
process with a tilde (~).
• A model le already on the memory having
the same name as the le to be copied will be
overwritten without warning.
Importing from SD card
Use the selection keys of the left or right touch
pad to select the “Import from SD” sub-menu then tap
on the SET key.
Copy flight sen kopieren
Erase model
Copy modell –> Modell
Export to mnach SD-Karte
Import from von SD-Karte
=>
OFFON
Please select
RF on/off?
If the message shown above should appear, the trans-
mitter's RF module is still active.
By pressing the central ESC button of the left or the
centre SET key of the right touch pad to cancel the
operation.
Choose contrast with the button left or right touch
pad to “OFF” and confi rm your choice with a brief tap
on the SET key, the process continues.
Model really
Ultimate
export?
NO
YES
02
A NO response will cancel the process and return
the screen to the originating screen. If the YES
response is selected then confi rmed with a tap on the
SET key, the selected model will be copied to the SD
card.
Notes:
• Should the notice …
SD-CARD
INSERT
OK
… appears instead of a screen for model
selection, there is no SD card in the
transmitter's card slot, see page 26.
• In addition to model data, binding data is also
copied by this process. This means that a receiver
system which was/is bound to the original model
memory can also be operated in the SAME
transmitter by its copy without establishing the
bond again.
• An exported xed-wing model will be stored on
the memory card in the \\Models\mc-32 folder
with a lename format of "aModelname.mdl"
and a helicopter model with a lename format of
"hModelname.mdl".
Safety, turn off but before a possibly in operation
receiving system.
Select the model to be imported from the SD memory
card with the selection keys of the left or right
touch pad.
03
04
01
11/06/06 06:06
Extra 300
02
Soarmaster
11/07/07 07:07
T-Rex 250
BellCobra
11/08/08 08:08
11/09/09 09:09
import from SD-CARD:
Note:
The export date posted at the right end of each model
name line is represented in the format "year/month/day".
After another tap on the SET key of the right touch
pad, the "import from SD-CARD" window will appear.
Now the destination memory location can be selected
with the selection keys of the left or right touch
pad then confi rmed with a tap on the SET key, or the
process can be cancelled with a tap on the ESC key.
A memory location which is already occupied can be
overwritten.
03
04
01
01:23hR16
Ultimate
02
Graubele
1234g/080811
00:44hR12
Starlet
BELL47G
00:33hR08
00:22hR08
Test
trim needed
Import to model:
free
05
After confi rming the selected model memory with a tap
on the SET key, a confi rmation request will appear:
To Next Page
Loading...
