77
Program description - Copy / Erase
model
Extra 300
import?
NO
YES
05
free
A NO response will cancel the process and return
the screen to the originating screen. If the YES
response is selected and confi rmed with a tap on the
SET key then the selected source model will be im-
ported into the selected destination model memory.
Notes:
• If the message …
SD-CARD
INSERT
OK
… appears instead of a screen for model
selection, there is no SD card in the
transmitter's card slot, see page 26.
• If a memory speci cally bound and in the
meantime on the SD card, for example, for backup
purposes, unlocked model is loaded back into the
original model memory from the same transmitter,
the receiver existing bond is retained.
• On the other hand, the same model is copied
to a different model memory, or even in
another channel, the affected receiver MUST
be re-bound.
• When a transmitter is speci cally bound and in
the meantime have stored on the SD card model
loaded back into any model memory from the
same transmitter, the receiver existing bond is
retained.
On the other hand, the same model is copied to
another station, the affected receiver MUST be re-
then confi rmed with a brief tap on the SET key of the
right touch pad. In the next window to appear …
7
Copy to phase:
3
5
=>
=>
2
4
6
1
8
… a destination must be selected and it must be con-
fi rmed too. Another confi rmation request will follow:
Phase to:
to be copied?
NO
YES
1 normal
2 Thermik
A NO response will cancel the process and return
the screen to the originating screen. If the YES
response is selected and confi rmed with a tap on the
SET key then the selected source model will be im-
ported into the selected destination model memory.
Storing changes permanently
Undoing changes
Storing changes permanently
If necessary, the program of the active model memory
can be “enshrined” with the help of this menu item,
the current status of the “uncommitted changes”,
which have been possibly already previously overwrit-
ten.
bound.
Copy ight phase
Select the “Copy fl ight phase” sub-menu with the
selection keys of the left or right touch pad then tap
on the SET key.
Copy flight en kopieren
Erase model
Copy modelodell –> Modell
Export to SD-Karte
Import fromn von SD-Karte
=>
OFFON
Please select
RF on/off?
If the message shown above should appear, the trans-
mitter’s RF module is still active.
By pressing the central ESC button of the left or the
centre SET key of the right touch pad to cancel the
operation.
Choose contrast with the button left or right touch
pad to “OFF” and confi rm your choice with a brief tap
on the SET key, the process continues. Safety, turn
off but before a possibly in operation receiving sys-
tem.
Tap to open the submenu, briefl y press the central
SET button of the right touch pad.
In the "Copy fl ight phase" sub-menu …
7
Copy from phase:
3
5
=>
=>
2
4
6
1
8
… the fl ight phase to be copied (1 … 8 for fi xed-wing
models or 1 … 7 for helicopter models) is selected
with the selection keys of the left or right touch pad
To Next Page
Loading...
