78
Programmbeschreibung - Menüs ausblenden
Undoing changes
Assuming that you already have at least once
pressed “save changes permanently” option in the
active model memory, you can “undo changes” the
active model memory as needed using the menu
item to reset the state of the last “permanently saved
changes”.
However previously no “changes will
be permanent,” the proper model
memory to the state at the begin-
ning of the programming model is reset !!!
Use the selection keys the left or right touch but-
ton and select the submenu, then tap the SET button.
Copy flight en kopieren
Export to SD
Import fromvon SD-Karte
=>
Store changes ft speichern
Undo changesgig machen
OFFON
Please select
RF on/off?
If the message shown above should appear, the trans-
mitter's RF module is still active.
By pressing the central ESC button of the left or the
centre SET key of the right touch pad to cancel the
operation.
Choose contrast with the button left or right touch
pad to “OFF” and confirm your choice with a brief tap
on the SET key, the process continues. Safety, turn
off but before a possibly in operation receiving sys-
tem:
Data is only backed up by "Store change" or a switch
from one model to another in the »Model select«
menu. Switching the transmitter on or off will not store
the permanently.
To store changes permanently, select the appropriate
line then briefly tap on the centre SET key of the right
touch pad. The confirmation request shown below will
appear:
Programming changes to be
NO
YES
store permanently?
A NO response will cancel the process and return
the screen to the originating screen. If the YES
response is selected and confirmed with a tap on the
SET key then the changes made since the last back-
up or model change will be stored permanently.
If, however, the changes made since the last backup
or model change are to be cancelled, then select the
line "Undo change". Following a brief tap on the cen-
tre SET key of the right touch pad, the confirmation
request shown below will appear:
Programming changes to be
NO
YES
reset to original?
A NO response will cancel the process and return
the screen to the originating screen. If the YES
response is selected and confirmed with a tap on the
SET key then the changes made since the last back-
up or model change will be stored permanently.
To Next Page
Loading...
